We are using HS output C2:51 DOUT G on an MC43 FS module, and we are getting open load errors displayed even though the setting 'DOUT under current detection' set to 'No'. I have downloaded the application from the system (because I wondered if the undercurrent setting hadn't been set correctly) and it was still showing 'No'.
Is this a bug or perhaps any other reason it could be causing problems? When energising the output using software we get no faults appear and the output states 'true' when measuring in IQAN Design. When we switch the output off, we get this error. We have a load of approx 100mA connected direct to ground.
Customer support service by UserEcho