1. Software
  2. IQANdesign
  3. Bugs
+1
Fixed

Wrong pin is shown in error message

Edzard 4 years ago in IQANdesign • updated by Gustav Widén (System support) 4 years ago • 4

On one of our mobile control systems we have encountered a situation where the wrong pin reference is shown on the display.

We have added a low-side output to our XC43, but it is not connected yet. The channel we have added is C2:65. Since we have not yet connected this output, it shows in IQAN with a red open-load indictor.

On our MD4-5 display however, the error message indicates C2:64 as the faulty channel. Might this be a refence error?

System:

IQAN 6.02.10.5706

IQAN MD4-5 (touch) master

CAN A: G11

CAN B: HS Exp: XC43

CAN C: Exp: XC21

GOOD, I'M SATISFIED
Satisfaction mark
Satisfaction mark by Edzard 4 years ago
+1
Edward Polzin 4 years ago

There is currently a known issue related to this.  Initially it was only the MC43, but appears to be the XC43 as well.  Thank you for pointing it out.

Tim Reen 4 years ago

We just encountered this problem on an XC44

Under review
Gustav Widén (System support) 4 years ago
Fixed
Gustav Widén (System support) 4 years ago

Fixed in 6.03

Customer support service by UserEcho