We experienced a similar issue with output energisation that was corrected in 3.16 but this is slightly different.
System is 1 MD4 with XC10 as expansion, 1 MC3 and 1 MC3 with XC10 expansion. We have logic that switches a single DOUT on XC10 expansion connected to MD4. This logic is handled in MD4 application. With a delay on of 500ms or less the output on XC10 remains low on module (tested using multimeter) but IQAN design when connected says high.
If I increase delay on to 1000ms the output switches on and voltage present on XC10 module using multimeter.
Its almost as if the MD4 is sending a command to energise output before XC10 has booted?
I have rigged up single MD4 and XC10 on the bench but been unable to replicate, perhaps cycle time of the software could be the issue? Running IQAN Design 3.19.
Customer support service by UserEcho