I have a design involving MD4 and MC2 multimaster setup in a Generic CANbus. MC2 feeding values to MD4 via CAN. When I run the simulation of the design the values do not seem to pass on to MD4 display. I have double checked the CAN frame address and field definitions and they are ok.
However, if I create a Simulation group for MD4 and get the channel updated directly from MC2, then I can see the value changing. But I'd guess this bypasses CAN messaging completely and uses Simulator's own message passing mechanisms.
Is Generic CAN messaging simulation something that is not supported? Or am I doing some fundamental mistake here?
Customer support service by UserEcho