Is it possible to have a 64bit, or at least a "unsigned" property for some channels?

I ran into problems when dealing with huge integers. For example, this won't work in the QCode of an IMAC:

X := 200100 * 56200

I guess "X" is automatically a Float, so it can't store such a large number. IMAC channels can hold a large number, but also if the most significant bit is on, it will end up as a negative number.

Same issue more or less with JPIN blocks. You can workaround it by chopping it up into 2 16-bit values, and glue them together later on, but it's not very elegant of course.

It would be nice if there where a parameter to change the decimal mark.

We are shipping machines all over the world and some regions uses ".", other uses ",".

The MD4 only use "."

Overview of decimal marks around the world

Is there a way to deploy IQANrun and IQANsimulate2 with an unattended, silent setup AND to also apply our license information?

If I update languages which are not main language (no 1 in the language list) then languages are not updating, but if I change main language column first and after that I change other languages columns then updating works! Also If I make corrections to Excel language document columns which are not main language then language importing doesn't work

I have an MD4-7 display and when I program it using IQAN Design 3.18, I can read PGN 42752 coming from address 27h. When I program the same display with "the same program" imported into IQAN Design 4.02, it does not work...

Screenshots

PGN42752.doc

1) the Splash screen does not show up at startup (Black screen shows instead)

2) when trying to load a new MD4 I get a message to load 3.7 or higher first before 4.02 program will load - this should not be required on a new MD4.

We are getting fault code 2 orange / 1 orange / 1 orange / 9 orange / 4 red / 1 orange on MC3 controller. Does this error code mean internal error/OSC (4:1 in MC3 manual)? If so is there any way of getting more information on why the controller is switching off and more details on that specific error code? Fault appears to be random and only sometimes goes into error state, sometimes module boots fine with no issues or error codes. System is 1 x MD4, 2 x MC3. Intermittent fault present on both MC3 controllers. Both MC3 controllers have CAN Open device attached to each. We have used these CAN Open devices before with success.

We are trying to capturing data in "measure group" of iQAN mc2 & mdl2. We kept both the controller in "B" (master Bus). We kept diagnostics in "A". CAN communication terminate frequently, during data capture. Can anybody suggest the possible solution?

We wanted to leverage some of the new features of IQANdesign 4 but have found that the backup camera no longer displays properly once updated from IQANdesign 3 (system utilizes an AXIS F1005-E camera and AXIS F41 main unit).

In IQANdesign 3, the camera displayed correctly utilizing the following video stream URL; http://root:root@192.168.129.10/mjpg/video.mjpg?resolution=%1x%2

In IQANdesign 4 the camera has to be added as a generic module and no longer displays correctly.The following is the information entered into the generic modules property inspector;

IP Address: 192.168.129.10

Username: root

Password: root

Path: http://mjpg/video.mjpg?resolution=%1x%2

Any help would be much appreciated!

Is there some possibility to change time and date directly in the program himself.