Hi, our construction plant field service engineers use the Samsung Active Tab 2 tablets for Mecalac dumpers as example, but one will not download the IQANGO app. It will though download the IQANRUN app, but as soon as you click go to IQANRUN it again says the device is not compatible. It does though work fine on other engineers running the same tablet. I have checked for all software updates, I have cleared google store cache and data, I have factory reset the tablet, but still when I search in google for IQANGO app and click install, it takes me to Playstore and says device is not compatible. Can anyone help with a workaround, or advise is it simply not possible?

no contact.docx
no contact.docx

Hi, are you all right?

I have this problem in the configuration below, which is the application for our double engine car.

At the insertion of the battery disconnect of the 1 st engine the alarm "mc43slave no contact" is activated because the other engine compartment has not yet disconnected battery on .

The two engine compartments have a distance of about 15mt .

You can avoid or delay this.

Is there a software command to send by can to accept and reset this alarm from another device (the Remote Control)?

Hi,

Please, where I can find the CAN Bus PGN documentation from MD3 and MC3 ??
Thanks

In my program it would be nice to adjust the delay on/off of a digital parameter in each state.

I wish the lines following a channel block (before and after) would be shown above all other lines and all other channel blocks. This would make it easier to follow. And preferably another colour to better distinguish it from other lines even better? Green?

Does somebody knows if it's somehow possible to find and replace text of names, messages etc. within a function group.

I copied a function group "Engine3" to "Engine 4" and want to replace all the E3 text to E4

Customer has issues with slow IQAN system update over IQAN GO and G11.

So I tested following setup:

1) I connected a wireless access point from Zyxel (WAP3205v2) to IQAN MD4 with the ethernet cable. 

2) I set the switch on Zyxel to Access Point mode (AP) and turned on Wifi with a switch.

3) I connected my iphone to this new wifi.

4) I opened IQAN GO,  selected Wifi and connected to my IQAN system.

5) I downloaded my IQAN file stored to the phone (size 26006kB). I took less that two minutes.

I closed the Script manager panel in View > Script manager. 

Now I can't open it again what ever I try.

Hi there,

For a project I have to couple an IQANs system with a RS485 sensor. I was thinking a J1939/ CanOpen to RS485 converter could work. Has anyone done something like this?

Thank you in advance.

Theleo De Bruyn

I'm having some strange problems with simulating a CIN channel.

setting:

min: 4000 uA

max 20000 uA

scaled min 0 

scaled max 1935

when simulating, the slider will not move within the 4000/20000 or 0/1935 range but between 1935 to 77400.

Design and simulate 6.06