System mismatch on XC44
Keep getting system mismatch error with Internal State: Failed 106 on a XC44 with a MC43 master and can find very little information as to what this means. It might have to do with us having multiple XC43 and XC44 modules in the project with different pinouts/configuration, which are then enabled and disabled using digital adjust parameters, as when I enable certain ones I don't get the error and then other ones I do. If I get a new module it will not complain after the initial upload, but as soon as I update it again, the error returns and does not go away. Any help with this issue or more info on what this error means, would be much appreciated. Thanks
Cout for j1939?
I am looking at a j1939 module with current controlled outputs that has conection ports that would be drastically more convenient in a perifial location than the the equivalent xc4x module. I know how to program for it, but what I would like would like to adjust it on the screen, like the native IQAN current outputs. Is that possible?
Problem using encoder for external display control with version 6.06.10.7344
I have problem using encoder for external display control (MD4-7). When using version 6.05.19.6064 everthing work fine.
With version 6.06.10.7344, the encoder(highlight square) select some images instead of the button is supose to select.
custom re-usable image group
In a similar vein as what was done with Custom re-usable function group. It would be nice to have the same for graphic objects.
We think consistency in a visual interface is critical to a well perceived information. For that matter, now that we can group images it would be very good if we could create library of standard object we can re-use though out a project or even across project or to display group of similar information. for example:
A lighted fault button:
or a pattern of repeating information:
Then modification of the master would apply to all. This would apply strictly to the object graphic options, Color, Size relative position. Each object group instance then can be associated with is own variables set.
Likewise and I had posted something like it to create within a project a set of "My colors" so we can keep color consistency a bit easier than what we do now.
Module redundancy
Idea: The ability to build in a redundant Master module. Installed so that they share state information over the diagnostic bus and automatically switchover if there is a failure.
The redundant module would disable CAN and physical outputs until swapping over.
IQANdesign - Corporate license
Will IQANdesign corporate license allow me to use IQANrun as well?
Thank you
Display page Bar Frames
We require display pages that have a White back ground due to visibility issues in the sun. The Bar frames are white and do not allow yo to change the color like other bars that are offered.
Other Bars change
Fault
It is impossible to find this errors, see attached.
I have imported the components from another project writed with IQAN5.08 and I have deleted unused componetns and parts of software unused
Paged Protocol Help
We have a CAN Open sensor that has 2 sensor outputs under index 6020 subindex 1 and subindex 2. I get ambiguous identifiers which usually we resolve using page protocols but these are normally different index numbers so straightforward to configure.
How do i configure paged protocols when they have the same index of 6020? (only the subindex differentiates each output).
Customer support service by UserEcho