In one of my groups I have a lot of I/O and when i go to simulate or measure when running the machine it gives me an error (measure terminated: request rejected by master module. (too many items are requested at the same time.)) This is becoming an issue because the diagnostics i need to see are in this group. i can make a diagnostics page but there would be over 100 items on it. is there any way to change how much data the master can transmit.

Hello

My client wants to use this camera.

http://www.ifm.com/mounting/7390715UK.pdf

Could you tell me if it works with the MD4 because I have a doubt and we can not.
Thank you

Hello,

Is there a easy way to compensate hysteresis of a hydraulic directional control valve with IQAN. Example: we need 50mA more to increase flow to a certain level than decreasing down to it from a higher standpoint.

Hello,

i need to comunnicate lots of i/o's between 2 master modules. Cant get this working with j1939 protocol.
Where can i find more information?
I've already studied the example Multimaster JFOUT file.

Just started an IQAN (ida4) with IQAN-Run 4.06. So it automatically opens the "Project View" tab, but I couldn't see anything but the left "Project Manager" list (see screenshot). Turns out the other middle/right panels were on the far right, beyond the borders of the screen. After minimizing/maximizing the screen, I eventually saw the drag-borders to restore the sizing.

Once restored, I could restart IQAN-Run without trouble. So I guess it had something to do with first-time usage.

However, I can't explain this through the phone to service people using IQAN-Run, they generally don't know much about computers. Besides fixing this issue, a "restore workspace" button (like IQAN-Design also has) would be nice.

Using a Windows 8.1 laptop here, resolution 1600 x 900, single screen.

Hello , I have an older MDL2 panel that suddenly gave an error message . ( see picture )

I can't get contact with the panel using design unless I start up in safe mode .

When I load the program in safe mode it will say the application is loaded but than when i start the MDL2 up again I get the same error .

Program used is Iqandesign 3.19.9

Is there a way to solve this or is the MDL2 broken ?

Best regards , Arthur

Is it possible to set a wake-up time on the MD4? I would like to power it on at certain date and time instead of leaving it on all the time. Is there a way to add this feature? Or should I consider leaving it always on? Basically, I want to start some procedure at a chosen time, but I also don't want to drain the batteries on my vehicle.

Thank you

Has anyone tried, or had success with using VLC's RTSP stream to work with a generic camera device in IQAN?

I tried a handful of settings but I couldn't get it working. Once thing I did notice in wireshark is the display was attempting to open a TCP connection with my PC (VLC stream server) on port 554 but I was under the impression that RTSP was UDP ?

I am very new to this software environment so I am just tinkering around. Its not something that needs to work, but why not right ?! :)

With the exception of the properties panel I can't seem to dig up any more information to help me out here.

Any advice or experiences would be greatly appreciated.

For some simple automatic modes I'm using Integer Parametar(Adjust Item) as speed setpoint in DMAC, like on the picture:

As this unit can go 360 all around, I would like to give it shortest path to final points, but for this I need to change direction of Controlling vars(for ex. Auto NEST Speed ,sometime need to be positive and sometime negative).

How can it be done, because I'm not able to find solution for this?