Time Values
Is there a way to break up the time elements in the SIC?
For example, I need to send another J1939 module the value of the minutes, but not the hour or the seconds.
IQANdesign 3.14.18 released
Changes and new features
22588 Send J1939 identification frames
A master will now respond to broadcast request for PGN 65242 and 65259 on a J1939 bus.- Software Identification (65242) will contain 5 strings: Project name, version, id, checksum and vmAC version
- Component Identification (65259) will map the following strings: Make = empty, Model = module type (e.g IQAN-MC2), Serial number = module serial number, Unit number = module address
Bug fixes
22547 Crash at startup on Windows XP
Fixed.22555 Master crashes upon DM1 reception if no DM1 is defined
Fixed.22574 MD4 stops working if external J1939 unit claims address 128
Fixed.22796 Remove "No contact" alarm for APPIN time-out
Before, a single lost APPOUT would trigger a warning message and log event saying 'No contact', even if all other APPOUTs from that module was received. The 'No contact' popup and log event has been removed. No change to the APPIN timeout and action.
Remote request frame on the CanOpen
Hello,
I woud like to send RTR "remote frame request". İts importanent for node guarding. How can we do it? is it possible ? Please advise.
Thanks.
Dimmed Light on MD4
2. And the button you press do disable the sleep mode but is not pressed in software, so you have to press again. This is I thinks because of the first point.
"Start Block" in COUT channel. What does it mean?
In both 2.6x and 3.19 programs, when the minimum current on a COUT channel is adjusted on an MDL2 when the output is sending current, the current goes to zero, and the channel appears yellow in Design. The error that the channels shows is "Start Block".
1) What does this mean?
2) Why does it happen?
Thanks!
Luke.
Interactive message channel with Help on MD3
on the MD3 the right button become help button.
It is ok if you know it but IQAN should disable the right button config if help text is there, to avoid confusing the developer.
Back-up camera: How can I overlay a grid overtop of the video stream to give perpective to the image?
Is there some way to set the lines to always be on top?
TSC1 question
and message checksum (SPN 4207)?
camera video format H.264
Hi,
Is there any plan to support H.264 camera video format? It is too hard to find any new camera still supporting MJPEG. They are all now in H.264 format.
Regards,
Frank
j1939 Source Address (read data sent to another module)
I am sending a message on PGN 55808 form a different source address than the Iqan module (from 250/0 instead of SA 33 which is the Iqan MD4). When I send the message - the engine sends a response back to SA 250 (0/250 on PGN 55808) which I can see on the bus with IqanAnalyse. If I read this channel (PGN 55808) with the Iqan - the response does not show up. Is there a way I can see the response to SA 250 with the Iqan MD4 set to SA 33?
Customer support service by UserEcho
