is it possible to have one numerical prompt asking for PIN but multiple pin codes, activating different PCC's.

As a login prompt, and based of the pin code one will have access/made visable to different buttons, menus adjust groups etc?

Hi!

i've got a canbus external control, grayhill encoder, which i've got set up in my application.

But how do i use the "External button controls" in the display pages section.

i could not find any good documentation of this.

Thanks!

Robin

does anyone here have a quick an easy way to start comunication between an MC43 via j1939 and an EVM25?

totally new to this modules and will like to get familiar with them, especially how to establish comunication with the darn thing?

Hello All,

I'm currently working on an application that requires a toggling digital signal to be sent over the generic CAN line at a rate of 50 Hz (on for 20 ms, off for 20 ms).... A third-party device that we need to communicate with uses this toggling signal as a redundancy check to confirm that another signal is valid.

Does anyone have an elegant way of making a square wave generator in IQANdesign that I could use as an input to the parameter?! Any suggestions would be greatly appreciated because I'm drawing a blank.

Cheers,

Paul

Hi

It's possible read pdf file on screen MD3?

I have assigned the Action property of a button on an MD4 display page to a text parameter adjust item. I would like to do the exact same thing from a button on an interactive message. Is it possible to call up the menu system or an adjust item using qcode or some other way besides using buttons on a display page? Thanks, Dan

I would like to be able to adjust CAN Network parapeters with a functional parameter so I don't need countless iterations of the same program to get mixed up.

For example; I use a dedicated bus to speak to the Chassis computers. Most vehicles run at 250 kbs, but more and more are 500 kbs.

Another example; Most joysticks will be on short enough wires to stubs, but some cases I will have to do dual joysticks both quite distant (wire-wise) from each other and the MD3. To make that work I will need to make them their own backbone and turn off the terminating resistor on the MD3.

just that quickly I have 4 versions of the same program I need to keep up-to-date.

I like to use the chair switch in a seperate IDC in the activating group, allowing movement from the moment the input has been zero. In that way, the output can not go to high speed when a person is holding a joystick when taking a seat. The joystick has to be "reset to zero" first. :)

We are keen to be able to attend some IQAN functional safety training if possible. Will there be some running either in the UK or Sweden in 2017?

Startup image is not loaded after sending clone file to MD3 or MDL2 with IQAN run 3.