We are getting ready to launch a product using IQAN Software. As we make major changes, how can we push them into the field? Without the customer needing to do a lot of work?

We have a MC43FS and MD4

Thank you

Hello,

It would be nice if we could set the date/time automatically through the IQANDesign application. We have a way of getting the current date/time from an external module, there's just no way as far as I know to force the application to sync with that time.

So I imagine it could look something like this

Some components have redundant CANBus inputs. IQAN can use these by having multiple CAN outputs assigned to different CANbus. It would be nice to have a built in function that could swap an output to a different bus automatically on bus failure or using a logic input.

When connecting with IQANgo the machine name can be selected and the app tries to get in contact with the master but then comes up with "no master module found" 

In this case we have MD4-7[0] and the diagnostics are connected to bus-D as well as the G11 module, via can-D i have communication through J1939 with MD4-7[1] who runs his own program and sends/recieves through J1939 as well. 

The G11 seems to have a conflict in choosing the master as the second display is on the same bus as the G11, when disconnecting the second MD4-7[1] the connection can be made without anny problem.

Below is only to explian the situation, MD4-7[0] has a different application as the MD4-7[1]

In a program, I always used multiple expansion modules with the same address with no problem.

this to select for different output setups (COUT instead of DOUT and so). via a setting one of the modules was enabled.

physically there is only 1 module but by enabling one or the other in the program is was possible to switch between the different setups

in Design 6.x this not possible anymore because it generates an Ambiguous address error.

any suggestion the deal with this

regards Ed

I noticed that IQANrun times out and disconnects from the master module when two conditions exist:

1. While accessing a large measure group.

2. While accessing J1939 device to view assigned messages under the system layout tab.

IQANdesign 6.04.9.5943

MD4-7 & XC43

I just diagnosed what I think is a bug for the current outputs. I have a COUT going to the max positive value, then while the COUT is at max, the channel gets disabled. When the channel is enabled again it turns on by itself at the previous value where it was disabled at. The length of time it stays at the previous value is affected by the ramp settings.

In my opinion the COUT should zero itself when disabled since that is the safe state.

I cannot see the files I am downloading from one MD4.

For example, the PY190173- (11ª-1521) SACH - 27-1-22 10.42.20 in the image of my mobile phone folder is not showed in the Manage files.

Can someone help my, please? Thanks in advance.

Adolfo

I can vary the transmit rate of the JFOUT channel with an integer parameter in an initialization group but I am not sure how to do this when the JFOUT channel is in an external function group. I do not see a way to use a constant channel in an external function group and have it point to the transmit rate. Any suggestions?