unable to receive destination specific pigeons in iqan desgin version 5 ,Please help me by providing idea of how to configure destination specific JFIN pigeons  

Hello

The C-standards of a lot of mobile machines forces the machine-manufacture to have for the operator/driver 24x official EU-languages. Service technician only need to have up to 4x languages. That's the reason that the operation manual must be printed in 24x EU-official-languages and workshop manuals only up to 4x. 

I can set up in Parker IQAN only one multi-language block. Would it be possible to have two multi-languages blocks available: one for the operator, one for the service technician.

Regards

Andy Pauly

It would be nice if multiple master modules could access the same IO of a single expansion module. As it is now, one master module would have to pass the  value to the other module. This would also allow for redundant master modules.

When the language is switched to Russian - the menus and messages are all blank even though in simulation they are all showing.  Is this a font issue?  Should I be using a different font for Russian?  It is set to default in the program.

I'm trying to let the user decide by using the Master display whether he wants to save the data in a measurement file or no. Is that possible to have a button which will allow me to Record the data in an Excel file? Does anyone have an idea how to do that?

For the calibration of a Gear speed sensor P/N:01712ECD, the gear that I'm using has 50 teeth, so I'm doing that calculation based on speed sensor output 10 kHz then 10000/50=200 rpm as my maximum rpm. Is that what I have to do in my calculations? 

For a new project where I have to make an inputs and outputs configuration, we are have running Iqan design 6 beta, our problem now is that is is not possible anymore to open iqan design 5 applications in Iqan design 5 by clicking the filename. All the applications are opening in Iqan design 6, and that SW doesn't support the older expension modules. 

The next problem is that for our data management container double clicking is the only way to open files.

It is also not possible to change the program by change the default program in the settings of windows 7 or 10.

I have uninstalled the 6 beta from my computer and I had a little bit of trouble to let the Iqan design 5 applications normal again.

Is this solved in the released design 6 version?

Kind regards Laura

Hi,

     I am new to this environment. if any one guide me on how to design and upload code to MC43 controller.

     Step by step guide will helpfull.

    Thanks in Advance

I'm using IQANdesign 5.04.14.5377. When laying out a new machines program, typically all the I/O is placed in the master application just as a place holder. Then, function groups are setup and the I/O is arranged into the desired function groups for programming the control logic. The issue is when a channel is dropped from the master app to the new function group, it lands way down the page. It take 20-30 sec. to grab the channel and move it back to the top of the page. is this a glitch or was this intended to be this way?  

I'm having trouble getting my MC43 to adjust date/time via the TDA message.

I am attempting to send the message through PCAN and I am simulating my display which has SA 18h.

The message I am sending is highlighted below 18D52718h

Time: 16:38:10

Date: 2019 May 21

TDA is enabled in the MC43 program and I am on CAN C.  Does it have to be on the diagnostic CAN bus in order to work?