We are having issues in the field with some of our service groups not being able to pull clones from our machines. I have attached a photo I was sent from the field. The machine in question has a MD4 [0] and two MC43s [1&2].

The program was installed using design 6.08.30. They are using Run 6.08

They have also tried using run 7 to pull the clone with the same results. Is this a bug or do we need to adjust a setting somewhere?

Hi,

I was just wondering if anyone had a good solution for a visual tilt coordinate system in a master display? I am trying to translate a tilt sensor to a visual depiction of something similar to a Leveler Bubble like the photo I have attached to this thread. When editing a display page, you cannot set the coordinates of an image to an input channel, so that a bubble could rotate freely around the page depending on the angle of the head. Currently, the only solution I have been able to come to is having many bubbles on the display page, and showing/hiding them depending on the position of the head using internal digital channels. This does take some time, and can be inaccurate depending on the increments between each 'bubble' on your page. Any help or ideas would be greatly appreciated.

Cheers,

Angus

Para conectarme en un equipo Weiler me pide licenciar el IQAN run5; pero este ya no esta disponible. Donde obtengo la licencia del actual run7?

If you close Iqandesign 7.03 via File > Exit it opens the help PDF.  I assume this is unintended behaviour?

After upgrading to IQANDesign 7.03.25 from 7.02.33, the XC43 module in our system shows "no contact" error, with R4:3 3:1:7 fault code blinking. The fault goes away after system restart, but randomly gets back after several restarts (cca. with 1:50 probability). Currently 2 of 15 identical systems shows the same issue. Reviewed the logs, the faults only came after the update (the machines were under tests for about 1-2 months with software made with IQAN Design 7.02.33). The firmware update to 2.02 was successful, as I see from module info.

MD4-7 - MC42FS - XC43 multimaster system.

We will tomorrow revert to IQANDesign 7.02.33. I hope the firmware reverts too from 2.02 to 2.01, as we have to deliver the machines soon.

Probable bug in XC4x 2.02 firmware?

In our application a bidirectional COUT output is used. In some machine configurations the second valve is not connected but this results in the Open Load message being sent on the display. Is it possible to disable this error message on the display?

Hello quick question because i was not able to find it in the iqan design documentation but am i right in assuming the Generic frame in channel is a "tigger" like function? What i mean is does it update when for example my sensor send back the data does it register that it has received that frame and trigger for example the parameter reading?

Hello,

I am seeking sample projects for the IQAN Design program to enhance my skills, starting from a beginner level. I would greatly appreciate any resources or examples that can support my development.

Thank you for your assistance.

It would be nice if it was possible to hide the close X button on the interactive massege.

this way the buttons must be used. and a selection must be made

Hi, when starting simulate form design I get the following error;

the simulation will run, but startup is slow, and design will not show actions (green squares)

Running 7.03