It seems that it is not possible to link a math integer or integer paremeter as J1939 source adress in external function....

Im having issues with some muxed j1939 parameters. I have seven sets of values that are using the paged protocol on the same PGN. What I'm finding is that i have a few of the PGN'S coming in correctly then if i make changes the ones that previously worked will quit working and the others will work.  Is there a limit to what the Iqan MD4 or  MC43 can handle? PGN is 65534 and page values are 79,77,90,7A,F7,F8,81. Im using a 0xFF page mask. Send times are as low as 10ms and as long as 200ms. 

Hello, I'm new to IQAN, where can I get solution library folder to look for IQAN program examples. I'm trying CAN communication between two MC43's but when simulating it using IQAN simulate I cannot see signal sent on JFOUT in JFIN, please help me with eg

Is it possible to show a log from a Module MC42 on a display module MD4? 

When trying to start a simulation i get the following error.
What could be wrong?
I choose 'New simulation'.

Is there a way to fix this - or replace the MD3?

Is there a way to get all the logs and settings from the machine at once?  Basically - We need a clone without all the operating systems.  It would make it much quicker to get and email.

If not can this be added to a future release for IQANgo and IQANrun?

Does anyone know how accurate an hour counter log will be when the events that cause the hour counter log to activate are sometimes in the range of 0 to 2 seconds? I am running a program where I need to monitor when a motor goes over a certain max RPM but quite often it is only going over the max RPM for less than 2 seconds. In most cases I only care about times when the motor is above the max RPM for longer periods of time which I know the hour counter will add up accurately, but I received a clone where my event counter showed that the motor had gone over the max RPM more than 3000 but the hour counter said that the total time above the max rpm was only 0.40 hours which works out to less than 0.5 seconds per instance. 

On IQANDesign version 6.02, I am experiencing a consistent crash when trying to copy a group of display objects. It does not crash with small groups of controls that do not require input channels (line, label). But if I try to copy a small group of a label and an LED, the program crashes every time. 

Hi

I have a question regarding the IQAN MDL2 display.

I have a system that uses this display and to it i have a couple of pressure sensors connected to it. i need to replace these sensors with a different pressure range, in other words i need to rescale the input from the software. what do i need in order to do this ?. do i need IQAN design or something else ?, and since i don't have the project file, can i simply upload it and edit and download it again to the MDL2 display ?.

Thanks in advance