Open Load Error when MD4 Output turns off
I am trying to control a relay with an MD4 output (relay turns on a light when certain conditions are met).
When the IDC channel that controls the DOUT channel goes to false (output turns off) the MD4 is displaying an OPEN LOAD error.
We are running IQAN Design 4.07 on this unit.
Any recommendations?
Looking for vehicle schematic example with display, controllers, joysticks and etc.
Need a good example of vehicle electrical schematic with Parker controls.
Resolution of PWM output
Hi!
When monitoring the output of the PWM it shows only values with no decimals although the input is with decimals. I have attached an example. Is it true that the resolution of the PWM output is discrete values?
why PWM instead of COUT?
I am planning to drive a proportional relief valve (AP04G2YR 21C) with a XA2.
Is there any reason to use a PWM output over a COUT?
With COUT, I would think I would have open and short circuit detection (not sure about PWM) and it would take into account the coil heating up over time.
Ground triggered digital input
Is there a way to configure an XA2 expansion module's digital input to accept a ground triggered signal without adding external resistors? I have an application that requires a grounded input instead of a positive voltage.
CAN Communication Distance
What is the maximum distance that the IQAN bus can transmit (in terms of cable length)? I can't find it in the documentation and I have a project that requires a display to be away from a hazardous area.
Reservdelar till IQAN-DG
Går det att få tag på reservdelar till IQAN-DG displaymodulen?
Jag har två problem med min, displayen har till 1/4 blivit svart (sprucken) och programeringsknappen tar mycket dåligt (brända kontaktytor)
PWM as control signal
We want to use Spal brush-less fans, these fans have integrated electronics that control the fan speed. the speed can be controlled by a PWM signal mr 0 to 100% frequency 50 to 200Hz.
Is it possible to use the PWM output of the Iqan system to control this?
Regards, Ed
ENVELOPE LINES ON CAMERA VIEW
Our customer would like to be able to see "envelope lines" on the IQAN camera view....similar to automobile backup cameras. Also, a way to allow a pop up alarm on top of camera view so operator is alerted to look to another page or view for fault.
wifi camera suggestion
Does anyone know a WiFi camera still using MJPEG format?
It looks like all WiFi cameras are using H.264 format now,
Customer support service by UserEcho