If you use the Asus WL-330NUL Router for wireless connection, is it acceptable to power this from Vref+ or do we have to provide a separate 5v power supply?

Is there a running list of IP cameras that have been tested for operation with the MD4 that have worked successfully?

I have a MC31 setup than is behaving unexpectedly. Some I/Os seem wrongly mapped in the software. When I toggle Dout J, the pin C1:17 does not change state, but outputs F-G-H-I seem to work normaly.

Also, reference A (on pins pins C2:1 and C2:2) is not providing 5V (in fact, I see 0V between those pins). Any analog sensor connected to this ref is obviously not working.


This is using SW 3.16.8.3850.

Please advise.

Why MD4 have a bigger application cycle time (min 25ms) compared to MD3 (min 10ms), even MD4 have more powerful processor than MD3 have?

We need as small cycle time as possible (10ms is maximum, 1 - 5ms would be ideal)

Our speed sensors give 1000 pulses (top speed) in one second (1 pulses in 1 ms). When software cycle time is too big the reaction time for the sensor signals is too slow and we don't get our system accurate enough.
That is the biggest problem with IQAN, the reaction time is too slow.

Is there any way to change MD4 / MD3 cycle time smaller?

Best Regards,
Tuomas

Hello,



I’m experiencing a MC2 VREF error high 6.60v show up on a MD4 display unfortunately the product is not currently here to troubleshoot but I would like to know if this may or may not be an already known Bug with master to master communication/hardware monitoring. In the MC2 I am not using the module diagnostics for VREF, however assuming it still reports that information to the headmaster.



This is on a 12v system and the only place the 5 volts is used is 7 switches (on/off) as a checksum/and direction change sense to high impedance analog inputs. I have done this before without issue however it was 2.6 software, this is the first one with 3.0 software.



I thought seeing as I can’t troubleshoot it at the moment I would ask and possibly save time if this already a known issue.